Heaters
Cartridge heaters, bed heaters, and silicone pads. Wattage, voltage, and control needs.
Showing 25 of 25 heaters
Fotek SSR-40DA
Common BOM SSR with documented counterfeit risk — verify authenticity before use in any mains application
40W 24V Heater Cartridge
Standard 40W cartridge from a trusted vendor — adequate for most printing, but 50W+ is preferred for high-speed builds
Silicone Bed Heater 250x250mm 450W
Voron Trident 250mm BOM standard — the community's first-choice silicone bed heater at this size
Revo High-Temperature Heater Cartridge
Niche high-temp cartridge — copper block only
Silicone Bed Heater 300x300mm 750W
Voron 2.4 300mm BOM standard — 750W at AC reaches 110°C+ quickly and holds it under print load
60W 24V Heater Cartridge
Highest-wattage standard cartridge in the prosumer ecosystem — 60W for maximum thermal headroom at high-speed printing
Edge to Edge Bed Heater for Annex
Purpose-built K3 heater with safety thermostat
V0.2/0.1 S1 Polyimide Heater
Genuine LDO S1 bed heater with screw-in thermistor
40W 24V Heater Cartridge 6x20mm
BOM fallback at minimal cost — measure resistance before installing, buy extras
60W 24V Heater Cartridge 6x20mm
High-wattage clone — fast heat-up but verify resistance before use; batch quality is variable
High Wattage Cartridge Heater for Chube
High-wattage Chube spare — Standard 80W
Omron G3NB-210B
Community's preferred SSR — authentic Omron from Digi-Key or Mouser eliminates counterfeit risk
Edge to Edge Bed Heater for RatRig
24 V edge-to-edge heater for the RatRig V-Minion
V6 40W 24V Heater Cartridge
Standard E3D cartridge for V6-family hotends — correct spec for any E3D-compatible block
Silicone Bed Heater 235x235mm 24V
DC 24V bed heater — no SSR required, but thermal ceiling is lower than AC alternatives
Edge to Edge Bed Heater for SnakeOil
Simple 24 V edge-to-edge heater for SnakeOil
50W 24V Heater Cartridge
The Voron community’s high-wattage standard — 50W ensures fast heat-up and thermal recovery at aggressive print speeds
Silicone Heater 300x300mm 600W
750W USA-stocked V2.4 300mm alternative to Keenovo — same spec, faster shipping for North America
Silicone Heater 250x250mm 500W
Western-stocked Keenovo alternative — ships from USA, same AC silicone spec
Panel Heater
Clean silicone panel heater approach for chamber heating — lower wattage than PTC but tidier installation
DDX PH4 50W Heater
Genuine 50W DDX PH4 spare
PTC Ceramic Fan Heater
Community AC chamber heating mod — effective but requires AC mains wiring inside the printer
Revo Heater Core
Integrated heater and thermistor module for the Revo ecosystem — excellent engineering but locks you into E3D’s nozzle system
50W Ceramic Cartridge
BIQU 6×20mm ceramic cartridge for V6-style hotends (2-pack)
Silicone Heater 160×160 — V-Minion/V-Chonk
160×160mm silicone heater pad kit (300W, 120V or 220V) for the RatRig V-Minion and V-Chonk.
Nothing matches these filters
No heaters are in that combination.