Tricorn Air
Tricorn

Tricorn Air

Contender Extreme flow An open-source hotend that re-thinks the heat block from first principles — and mostly gets it right.
USD $230
Max Temp 500°C

Where to buy (1)

Listed at ~$230 USD. Vendors set their own prices.

Excit3D (opens in a new tab)

Full Specifications

Max Temperature 500°C
Heat Break Inverted
Heat Block Copper
Nozzle Thread V6 (M6)
Mount Style Dragon Mount
Fan Size Active (user-sourced)
Thermistor PT1000
Heater Type Cartridge
Weight 65g
Part Number TRICORN-AIR

Pros & Cons

Pros
  • 500°C component temp ceiling
  • Inverted heatbreak keeps threads out of melt zone
  • 3x 40W 4mm heater cartridges — higher combined surface area than a single 6mm
  • M3/M4 hardware only — no tiny screws
  • Dragon-compatible mount
  • Air or conduction cooled variants
  • Open-source design (CC BY-NC 4.0)
  • Passive heatsink holds 118°C with block at 260°C uncooled
Cons
  • Newer brand with smaller install base than Phaetus
  • Fewer documented Klipper configs in the wild
  • 4mm heater cartridges are less commonly stocked than 6mm
  • Open-source license is CC BY-NC — commercial use requires a separate license

The Tricorn gets noticed because it does something unusual: it inverts the heatbreak so the threads sit outside the melt zone rather than inside it. The practical result is better thermal isolation and a cleaner boundary between the cold and hot zones. It's not a marginal improvement — it changes the geometry of heat transfer in a way that most conventional hotend designs don't address.

The heater arrangement is equally unconventional. Three 40W 4mm cartridges instead of one 6mm cartridge. The combined surface area is higher, the wattage headroom is substantial, and if one cartridge fails you still have two. 4mm cartridges are less commonly stocked at general electronics suppliers, which is the main sourcing consideration.

The M3/M4 hardware-only rule is a quality-of-life decision that experienced builders will appreciate immediately. No M2.5 screws to strip. No M1.6 anything. Every fastener on the unit is a size that most builders already own drivers for.

The air-cooled variant is the standard install. The conduction variant is for enclosed high-temperature builds where chamber temperatures make fan-cooled heatsinks work harder than they should. Both share the same Dragon-compatible mount, so existing toolhead mounts work without modification.

The project is open-source under CC BY-NC 4.0, manufactured by Excit3D, Fabreeko, and Lettucehead3D. Physical units are vendor-specific in some details — check your vendor's spec sheet before ordering.

Where to Buy

Source files

GitHubtricornhotend/tricornhotend.comCommunity project: BOM, print files and build docs.(opens in a new tab)