AWD CoreXY Advanced

Mammoth-3D AWD Gantry 300

by @mammoth-3D-DevTeam
Motors 4× NEMA17 — 2 additional vs stock for all-wheel-drive
Belt 6mm GT2 open loop
Fits 1 printer
Printed Parts 40
License GPL-3.0
Motion Type AWD CoreXY
GitHub — mammoth-3D/Mammoth-FDM-MODs →

Fits On

Voron 2.4 300mm Primary target; designed and tested for this build volume
Can also fit (with modifications)
Voron Trident 300mm Minor modifications to Z attachment points required

Compatible Toolheads

Voron Stealthburner Primary CW2 Clockwork 2 Dragon Burner With adapter MGN12 toolhead carriages

Motion System Details

Motion TypeAWD CoreXY
Motors4× NEMA17 — 2 additional vs stock for all-wheel-drive
Belt Spec6mm GT2 open loop
Rail SpecMGN12H on X, MGN9C or MGN12H on Y

Build Complexity

Difficulty Advanced
Printed Parts 40 parts
Print Time ~25–35 hours total

AWD (all-wheel-drive) in the context of a CoreXY printer means driving all four belt attachment points with independent motors — two A-motors and two B-motors — rather than the standard configuration of one per axis. The Mammoth-3D AWD Gantry 300 implements this on a Voron 2.4 300mm by replacing the stock single-motor-per-axis arrangement with paired motors at all four gantry corners. All four motors work together: on a pure X move, both B-motors spin the same direction while both A-motors oppose them; on a pure Y move, the arrangement reverses. The firmware (typically Klipper with a custom kinematics configuration) sums the forces at each belt anchor point in real time.

The primary benefit of AWD over standard CoreXY is belt tension consistency under load. In a standard two-motor CoreXY, the single A-motor and single B-motor each drive a long, continuous belt path from one corner across the full gantry width. At high accelerations, the belt stretches asymmetrically — more tension near the motor pulley, less at the far anchor point. This shows up as ringing artifacts that input shaping can reduce but not fully eliminate, because the frequency response varies with toolhead position. AWD distributes the drive force to both anchor points simultaneously, keeping belt tension consistent across the full travel. Community builders report measurably lower ringing residuals and the ability to push acceleration targets higher before print quality degrades.

The tradeoff is real. An AWD gantry requires two additional stepper drivers — standard Voron 2.4 electronics (Octopus, Spider) have enough spare drivers for this, but the wiring adds complexity. Klipper needs a custom printer.cfg section to define the paired motor relationships. You're also printing roughly 40 parts versus the standard gantry's 15–20, and every motor mount, idler bracket, and belt path must be squared to tighter tolerances than a two-motor system, because any asymmetry between paired motors on the same axis causes torque imbalance rather than simple skew.

This mod is for builders who already run a well-tuned standard Voron 2.4 300mm and want to push further. If you haven't fully calibrated input shaping, pressure advance, and resonance compensation on your current gantry, that work should come first — the gains from AWD only become meaningful once the rest of the machine is dialled in. For builders at that level, the Mammoth-3D AWD Gantry 300 is one of the most thoroughly documented community AWD implementations available.

Community Resources