BD Sensor M
Open Source / Community

BD Sensor M

Contender Budget eddy probe with real-time Z compensation and a 1.5 g coil for hot chambers; still a niche Klipper project
USD $28.99

Where to buy (1)

Listed at ~$29 USD. Vendors set their own prices.

Fabreeko (opens in a new tab)

Full Specifications

Type Eddy Current
Repeatability ±0.005mm repeatability (contact/collision-sensing mode; per project README)
Installation Complexity Medium

Pros & Cons

Pros
  • Real-time Z adjustment without waiting for a bed mesh before every print
  • Lightning-fast bed meshing with no Z-axis up/down moves per point
  • Only a 1.5 g coil sits on the toolhead — the lightest eddy probe; PCB mounts remotely
  • High-temperature chamber ready (120°C rated), since all electronics sit away from the hotend
  • CAN bus supported; works with Klipper and Marlin
  • Nozzle collision sensing gives auto Z-offset and overcomes temperature drift of the mesh
  • $28.99 — far cheaper than Beacon/Cartographer eddy probes
Cons
  • Requires a conductive bed surface (steel/PEI-laminated); invisible to glass or Garolite
  • Klipper module and wiring setup — not plug-and-play; EXP1 pin order must be checked and only one connector used
  • Short-term preorder at Fabreeko (ships in 7–10 days); small community vs Beacon/Cartographer
  • Published ±0.005mm figure is contact-mode repeatability; no standalone eddy-distance accuracy published
  • Stiff 1.8mm coaxial cable to the remote coil must not be bent sharply

Where to Buy