GBB15
skuep

GBB15

Contender Niche gantry A/B driver for PrintersForAnts builds
USD $39.99

Where to buy (2)

Listed at ~$40 USD. Vendors set their own prices.

Fabreeko (opens in a new tab) West3D (opens in a new tab)

Pros & Cons

Pros
  • Two TMC2209 drivers on the gantry cut umbilical wiring to just CAN + power
  • Doubles as a USB-to-CAN bridge for Voron 0 / Trident
  • Open-source design with full KiCad, BOM and Klipper config on GitHub
  • Sold assembled by Fabreeko and West3D at $39.99 — no JLCPCB order needed
Cons
  • No hotend heater or fan outputs — gantry motors only, not a toolhead board
  • DIY heritage: work-in-progress repo; self-build needs JLCPCB assembly plus hand-soldered parts and a thermal pad to the extrusion
  • Must remove the 120R CAN termination resistor to run an umbilical to a CAN toolhead
  • Niche fit: designed for 15mm extrusions / PrintersForAnts Micron builds

Where to Buy