U2C v2.1
BTT

U2C v2.1

Contender Essential bridge for non-CAN mainboards
USD $23.99

Full Specifications

MCU STM32G0B1C8 64MHz

Pros & Cons

Pros
  • - Enables full CAN bus toolboard setup on any mainboard with a free USB port
  • - Small and inexpensive (~$8) — lowest cost path to CAN bus
  • - Plug-and-play with EBB36 and most BTT toolboards
  • - Supported by Klipper's USB-CAN bridge mode
Cons
  • - Not a toolboard — provides zero extruder, hotend, or fan control
  • - Mainboards with native CAN (Octopus Pro v1.1, Manta M8P v2, Leviathan) don't need this
  • - Adds a USB device to manage and an extra cable to route
  • - Known RF interference issues with BTT Pi or Manta CB1 near Beacon probes — inline USB hub required as workaround

Where to Buy