Home / Tools/ Retraction Calibration

Retraction Calibration

Generate a retraction distance tower test for direct drive or Bowden setups. Each tower uses a different retraction distance — find the cleanest travel move and you have your value.

Towers 12
Retraction Range 0.5 → 6.0mm
Est. Print Time ~18 min
Firmware Klipper
Updating…
 

How to use

  1. Configure settings. Select a preset to fill common values. Set your retraction range: 0.5–2.0mm for direct drive, 2.0–7.0mm for Bowden.
  2. Download and print directly. Do not slice this file. Load it in Mainsail, Fluidd, OctoPrint, or from SD card and print as-is.
  3. Inspect the travel moves between towers. Too little retraction: strings bridge between towers. Too much: blobs on resume, gaps at layer start.
  4. Find the cleanest tower. Count from left — the leftmost tower is your start distance. distance = start + (index × increment). Apply this value in your slicer retraction settings.
Reading the retraction towers
Too little retraction strings between towers Correct clean travels Too much retraction blobs on resume
Klipper: set retraction in your slicer — it passes G1 E commands directly. Or use SET_RETRACTION if firmware retraction is enabled in your config.
Marlin: M207 sets firmware retraction distance. Enable FWRETRACT in Configuration_adv.h. Or configure retraction in your slicer profile directly.