Home / Voron / Enclosure

Enclosure for Voron 2.4 & Trident

A proper enclosure is what separates a Voron from any open-frame printer. Panel material, sealing quality, and filtration determine whether you can reliably print ABS and engineering materials. These are not afterthoughts — plan them from the start.

Showing parts for: Voron 2.4 Switch model →
Seal it properly and filter the fumes An unsealed enclosure can't reach or hold printing temperatures for ABS — the chamber temp goal is 55–65°C. VHB foam tape around every panel is the minimum. If you're printing ABS in any occupied space, add the Nevermore or similar active filtration. The VOC output from ABS without filtration is significant.

Enclosure components

5 products
Contender
TAP Plastics / ePlastics
Polycarbonate Panels
3mm thicknessBest heat retentionCustom cut to size

Polycarbonate is the best panel material for high-temp printing — it holds up to 110°C+ chamber temps without deforming and provides better heat retention than ACM or acrylic. Order custom-cut from TAP Plastics (US West), ePlastics, or a local plastic supplier. Measure your frame panels carefully before ordering.

Buy at TAP Plastics →
Local fabricator
ACM Composite Panels
Aluminium compositeLightweightRigid

Aluminium Composite Material panels are lighter than polycarb and easier to cut locally. Heat retention is slightly worse than polycarbonate for high-temp chambers. Popular with builders who want a more industrial aesthetic or have access to local metal fabricators.

Buy at Local fabricator →
3M
VHB Foam Tape Seal Kit
Panel sealingHeat resistant~$12/kit

The standard sealing solution for Voron panel gaps. 3M VHB foam compresses around the panel edges and creates a decent thermal seal. A properly sealed enclosure can reach and hold 60°C+ chamber temps, which is the target for printing ABS without warping.

Buy at Amazon →
GDSTIME
GDSTIME 60×20 Blower
60×20mm24VExhaust / recirculation

The go-to exhaust fan for Voron enclosures. Used for chamber exhaust to push filtered air out of the enclosure, and as the recirculation fan in the Nevermore filtration system. $8 each means you can buy two or three without worrying about it.

Buy at Amazon →
Nevermore3D
Nevermore Micro V5
Active carbon filterKlipper controlledPrint + BOM ~$20

The community-standard active carbon filter for Voron enclosures. Print the housing (ABS/ASA), source the BOM (~$20 in parts: carbon pellets, magnets, fan), and run it with a Klipper macro. Filters VOCs from ABS/ASA printing — essential for enclosed spaces. Recirculates heated air rather than exhausting it, helping maintain chamber temp.

Buy at Community BOM →

Affiliate links used — Modern Makes may earn a commission on purchases. This doesn't affect our recommendations. See disclosure.

Panel material comparison

Material Heat retentionMax tempWeightCostLocal sourcing
Polycarbonate (3mm) ✓✓ Excellent 110°C+ Medium $$ Plastic suppliers
ACM (3mm) ✓ Good 80°C Light $$ Metal fabricators
Acrylic (3mm) OK 60°C Medium $ Hardware stores

Acrylic panels can work but may warp near the bed at high chamber temps. Polycarbonate is strongly recommended for enclosures targeting 60°C+ chambers.